Little Suitcase

 

I found this little suitcase picture on Pintrest there was no instruction an where I could find so I sort of made it up as I went along.

So here is a piece of the picture I found. The original is quite long but you get the idea.

 

Materials used; I used a pillowcase, a old scrub shirt, a pair of old jeans, and a two longish coat zippers I had kicking around.  For my trial run I decided not to use any interfacing or batting between the layers, to save my poor sewing machine some work (denim is quite thick and I find that the standard home sewing machines do not like to many layers of it at one time,   find three is about the max before I start to have problems).

 

So First things first, because I’m using finished garments/linins I have to cut open the finished seams so I can lay the pieces flat.  For this bag I’ve cut down the front seam from the zipper and all the way around that seam to the back, so that the piece I’m left with is one of the back pockets and one off the front pockets (can be seen better in the next picture).  To reduce a little bulk at the waistband of the pants I cut it open leaving enough fabric to attach a lining fabric to (aka the pillowcase). For the back piece of the bag front (the pocket piece forms a large front pocket on the bag front) I cut a piece of the pant leg the same length as the pocket piece, and again to reduce some of the bulk used the pillowcase to line the unseen part at the bottom( this will ultimately be the inside of the large front pocket).

 

Next I pinned the pocket front to the back piece,  trimmed the edges, added the piece for the inside lining (I used the scrub shirt for this) and basted all the pieces  together.  I also cut the back bag and back lining pieces and basted them together. 

This is also a good time to make sure any pockets you want on the inside are sewn in before you baste the pieces together.  And what kind of of handles or  strap you want to attach.  I used so 1 1/2 inch wide twill tape from my stash. 

 

 

Using the the pant legs for the zipper band I made one long rectangle (long enough to fit around the bag) and the matching lining piece.  With both fabric and lining  cut the band to accommodate the zippers.

Because I used two coat zippers I put the tops together at the center top and stitched them in.

 

Next I joined the zipper band to the bag front and back starting from the center top and working my way down each side. this is the time you would add piping to the out side of the bag if you like, you also could sew you seems to the out side and bind them the same way I did it look pretty good too, I did my seem to the inside and no piping.  I made my Bias tape out of some of the pillowcase so it would match, but you could use store bought if you like.  Notice I've left most of the bottom open and free, I'll show you why in a later step.

 

So here you can see the pockets on the inside front and the stitching for my handles, I’ve also started to pin my bias tape around the seems for a nice clean finish inside the bag.  This time I started from the bag bottom and worked my way all around the seem of the bag.  do the same to both sides. 

 

Next I attached the bag bottom to cover the zipper ends from the out side, for this I used a small rectangle of fabric from one one the pant legs. I’m surer there a better way to do this but all in al this worked ok.  I sewed this piece on by machine, just remember not to  sew over the zipper with your machine if you’ve used a large metal zipper like I have.

 

For the inside bottom I used a piece of the pillowcase to match the bias tape, this piece I stitched in by hand

And here she is the finished bag, I think it’s super cute!