DIY Explorers Play Tent

 
After seeing the play ten tutorials on on Pintrest I thought I would give one a try for my little man, and it give my hubby some thing to channel his energy into.  So we went out to the hardware store for some supplies.  What we came home with was 2 – 1x2’s that were 8 ft long and a 5/8 inch dowel.  When we got home we raided the linen closet, yet again and pulled out this twin sized sheet set.  It kinda reminds me of the turn of the century explorers (i.e.. Indiana Jones) or an African safari.

So now with our materials in hand we headed out for the back yard.  We started  by cutting our 1x2’s in half, so they are roughly 4 ft long, and drilled a hole in one end of each of them.  We used a 5/8 inch drill bit because we wanted to have a sung fit so the dowel didn't fall out of the holes well the kids are playing with it, and we didn’t want to use any glue/hardware because we still wanted to be able to fold it up or take it apart for storage purposes.

Here’s a picture of just the frame, really Simple and supper quick for this part.

And here is a picture of the the sheet over the frame.  This is where all tutorials I saw online stopped, but we decided to add “doors” (flaps that open and close) to the front and back. We also added a tube at the top to run the dowel through, so it wasn’t sliding all over the place. All you do to make the tube is fold the sheet in half and run a line of stitching down the center along the fold, keeping in mind that the tube your making needs to be big enough to run the dowel through.  On mine I sitched about an inch from the fold.

 

As you can see we used the flat sheet for the main tent portion and I used the fitted sheet for the ends.  We started by removing the elastic from the ends and cutting the seams out of the corners.  Then we folded the sheet in half and cut down the center to make two end panels, then we folded each end panel in half and cut to make the opening for the flaps.  Then we finished the ends that would become the opening of the door (fold over twice and stitch), and hemmed up what would become the bottom of the door panels.  For the the closures on the doors we used  Velcro on one side and on the other we used twill tape for ties.

We also add some ties to the side to help support the weight of the sheet on the frame and so we could tie the doors open.

The tent has been a big hit, my kids and all the neighbor kids have been play in it nonstop.  If you make one and add the doors like I did make sure your elastic loops are on the out side of the tent, I have to go back and move mine, but other then that it works great! and cost less then $15.